location:HOME > Service > Connection

FAX:0533-7688068 
ZIP:255410 
ADD:NO.6,QINGTIAN ROAD,QILU CHEMICAL INDUSTRIAL ZONE,ZIBO,SHANDONG,
CHINA

Connection

Electric smelting connection

A connecting method to insert the connection part of tubing or pipe into a special electric smelting tubing with resistance wires buried inside and power on to heat until the connection part is fused as one applies to the connection of 32-315 tubing.
Electric smelting connection requires that welding machine has a stable output voltage and satisfies connection requirements and operation specification for tubing and pipe connection. Welding machine and electric smelting tubing should be connected correctly

 

The procedure is as follows:

     
1、Measure and mark the inserting depth or welding area on tubing (such as saddle-type tubing) with a marking pen. Pay attention that the tubing end face should be cut perpendicular to axis. 2、The oxidation layer in welding area must be completely cleaned before welding. 3、The welding surface of tubing and pipe must keep clean, dry and greaseless.
     
4、Insert welding end of the tubing into the interface until the limiting shoulder of tubing or marking depth on main tubing. The tubing and pipe must be installed under stress-free condition. 5、Insert the welding machine into tubing jack and accurately input welding and cooling time marked on the tubing. Or directly scan barcode to input welding parameters. 6、When the preparation work is ready, press the enter button. The welding machine will again display welding parameters. After a full confirmation, press start button again to begin welding. When the welding is finished, alarm is prompted automatically. And then welding procedure ends.

 

 
 

 

ZIBO JIELIN PLASTIC PIPE MANUFACTURE CO.,LTD. All Rights Reserved